Blagdon Amphibious IQ 2250-4500 15-25W Pond Pump

Blagdon Amphibious IQ 2250-4500 15-25W Pond Pump
Blagdon Amphibious IQ 2250-4500 15-25W Pond Pump

Blagdon Amphibious IQ 2250-4500 15-25W Pond Pump

Suitable for waterfall and filter, low maintenance, high performance, digital motor technology uses around 30% less energy than similarly priced pumps. Flexible power usage control and display, with touch button stop, start, increase or decrease power and flow. The Motor Protection System detects if the motor is clogged or jammed; a warning will be displayed with an instruction to resolve problem. The Run Dry Protection System detects insufficient water; the pump will pause, and a warning will be displayed.

Pump restarts when water level safe. Soft Start allows flow will increase slowly to pre-set position, reducing wear on the pump and decreasing stress to the pipework and your filter.

Use to run filter only. Use to run waterfall Only. Use to run waterfall & fountain. Waterfall Width at 1.5M (4'9)/Head Regular Flow Rate. Waterfall at 1.5M (4' 9)/ Maximum Pond Capacity.

Pump type & model number. 7,350 litres (1,617 gallons). 17.3cm (6.8) / 3,150 litres (693 gallons). 8,850 litres (1,947 gallons). 32.1cm (12.6) / 5,850 litres (1,287 gallons).

13,050 litres (2,871 gallons). 42cm (16.5) / 7,650 litres (1,683 gallons). 16,800 litres (3,695 gallons).

51cm (20) / 9,300 litres (2,046 gallons). Under normal running conditions the display on the controller will show you the current power consumption of the pump. This can be altered through use of the increase/decrease power buttons.

However, there are pre-set programmes on the controller designed to increase the levels of protection for the pump, preventing overheating and damage to the impeller. These functions are identified by the scrolling text displayed on the controller.

See below controller warning messages and actions required. Jammed, Clean Impeller, Clean Rotor.

An object has caused an obstruction of the impeller - stopping it from being able to spin. Turn off the pump at the socket, open the cage, clean the impeller and impeller chamber and remove any obstructions.

If the pump has remained blocked for a period of time the display will read "jammed clean pump clean rotor reset power". After cleaning turn the power off at the mains supply for a minimum of 5 seconds to enable the pump to run again.

The water level in the pond has dropped. Add dechlorinated water to raise the water level back to the original depth. If the pump has been without water for a period of time, the display will read "low water add water reset power". After adding water or solving any leaking issues, turn the pump off at the mains for 5 seconds to enable the pump to run again.

Check Pump Cable and Connector. Either the plug from the pump to the controller has not been connected correctly, or there may be damage to the pump cable.

Ensure the plug is fully inserted into the socket on the controller. Check cable for any damage, if damage is found, cease using the pump. After ensuring the connector is correctly inserted, turn the power off at the mains supply for a minimum of 5 seconds to enable the pump to run again.

Maximum flow at 0m head (litres per hour). Maximum head (on maximum power).

This item is in the category "Garden & Patio\Ponds & Water Features\Pond & Fountain Pumps". The seller is "linersandcovers" and is located in this country: GB. This item can be shipped to United Kingdom.


Blagdon Amphibious IQ 2250-4500 15-25W Pond Pump