HydroForce Rainwater Harvesting Clean Water Pump Series 3 is a submersible rainwater tank pump - electronically controlled, pressure sensitive, centrifugal roto-dynamic with no reciprocating parts. There is a built-in non-return valve and double dry-run protection. Underwater or surface mount water pump.HydroForce Rainwater Harvesting Pump has been engineered by HydroForce Pumps Ltd in Peterborough, England to respond to the demand for the highest quality pump for use under water in rainwater harvesting tanks. Using the most rugged components it has been exhaustively tested for trouble-free running. The pump features a self-controlling pressure switch, dry run protection and a non-return valve. It is suitable for total immersion in tank water or it can be externally connected to the tank above ground. The Series 3 will deliver up to 3.5 bar (household pressure is around 2.5-4.0 bar). If connected to a hose or tap, the pump will automatically start to pump water when the tap or hose is turned on. The pump delivers over 2500 litres per hour using a 1 connector and uses 800 watts at 220-240v AC delivered by a 5 metre cable. The exterior bodywork is an Italian-styled shape which is stable in the floor of a water tank. The pump and electrics are totally new, engineered to give more reliable underwater performance. Now an alloy bulkhead, pressure release gap and twin chamber design prevent ingress of water to motor, electrical components and to bearing oil. At the factory in Peterborough each pump is tested individually, pumping water through a pre-determined cycle to ensure performance is to spec, and the performance of each pump is automatically logged against its bar code number to assure the client of its quality. The HydroForce Series 3 is an electronically-controlled, pressure-sensitive, submersible, centrifugal roto-dynamic pump with no reciprocating parts. Pressure-sensitive (demand) pump switches on and runs when there is a demand for water. Max head (nominal) 35 metres, pump pressure (nominal) at outlet 3.5 bar, max. Dry-run Protection: when no water is detected for 8 seconds, the pump is turned off by the printed circuit board (PCB) in order to protect the motor and pump from burning out. Automatic reset after a period of 30 minutes. If water is still not detected, subsequent reset periods are 1.5 hours, 3 hours, 7 hours, 12 hours, 24 hours then back to the beginning of the cycle. Additionally, a thermal switch, not connected to the PCB, turns the pump off if motor overheats. It resets when cool which make take several hours. Electricity consumption 800 watts at 220-240 Volts AC 50 Hz (requires 10 or 13 amp fuse and RCD mains socket). Inlet port to the non-removable filter 1 inch (25mm) female BSP. Output port 1 inch (25mm) female BSP provided with push-fit connector for 1 inch (25mm) MDPE pipe 1 ¼ inch (32mm) connector option by special order. Dimensions L 565 W 185 H 260 mm, weight 13.1 kgs. The item "Submersible High Powered Clean Water Pump" is in sale since Tuesday, June 23, 2020. This item is in the category "Garden & Patio\Other Garden & Patio". The seller is "rwhltd11" and is located in Peterborough. This item can be shipped to United Kingdom.