VEATON 350W Submersible Water Butt Pump, 4000L/H Rain Barrel Water Pump with Flo
VEATON 350W Submersible Water Butt Pump, 4000L/H Rain Barrel Water Pump with Float Switch Drainage Water for Rain Barrel, Water Tank, Ponds, Pools, Cellars and Hot Tub. The innovative water butt pump is designed for pumping water from a rain barrel or rain collection tank.
Comes with a high quality plastic housing with aluminum swan neck extension pipe, and a snap on connector. Standard garden hose connector systems.
350 W powerful motor with a Maximum drainage rate up to 4000 L/H, Max. Immersion depth is 7 m and Max.
Supplied with 8 m cable and approved plug for wide range of use. Float Switch & Overload Protection? The pump will automatically shut off once the float switch below the minimum water level, avoiding dry running. When the built-in thermal motor protector overheats, the pump will automatically switch off, and rework again after cooling down. It can bring safety and long-lasting work to the pump. Automatic Mode: pump is controlled by float switch, it'll turn ON/OFF the pump according the water level. Manual Mode: attaching the floater on the side slot, then the pump becomes compulsively at "ON" position all the time and is controlled by cable plug.This can be used when water level is low and not enough for floater freely floating in the water. Ideal for for use in the home & garden. Pumping Clean water from water butt directly to water plants in the garden.
It can also be used to drain water tanks, ponds, pools, flooded areas, boat, etc. Seal Structure with Thermal Protection. The pump body is made of ABS, resists corrosion.Lightweight and handle design makes the pump easy to store and carry. Product size: 19(L)x14(W)x28(H)cm, and the height will be 115cm with two metal tubes.
Flexible pipe end piece with kink protection and shut-off valve. Fits standard garden hose connector systems. Adjustable telescopic tube for adjustment to the height of the rain barrel. Easily open the grey base to clean and change the dirt filter. The pump is designed to work with clean water (solid passage = 0.2).
Don't use the pump for any. Salt water, chemical or acid liquid.It may reduce the lifetime of pump. Minimum Water Level for Pump Start. Minimum Water Level for Float Switch Automatically Starts from. Minimum Water Level for Manually Starts from.
Pump can removes water down to. Minimum Residual Water Level is.With a discharge head of up to. The maximum output can be. If the water level is not high enough for float switch freely floating, fix the float to "ON" for manual operation. Just be careful to dry running with this mode. Before starting, tilt the pump to remove all air and wait 15 seconds.
If pump is running but there is almost no water coming out. The pump may happen air block. Please tilt the pump into water for a few seconds and expel the air inside of the pump. If pump runs for a while, then stop then after a few minutes they restart again. Please check the pump again a few hours later, it may trigger the thermal protector because of overheat.The pump will work again once the motor cooling down. If you hear humming after plug in, the pump should still work. GHT 3/4 and Quick Connector.
1", G1", 1-1/4" and G1.5". Rain barrel, water tank, ponds.
41.1 x 26.6 x 18.2 cm; 4.2 Kilograms. We reserve the right to cancel any order for any reason at any time.
We are not responsible for undeliverable addresses. Your feedback very is important to us, after you get your package and you are. Thank you for shopping with tosdeals.